IDEC High Performance Series - Manual (Page 1141)

WindO/I-NV2 User's Manual 25-15
1 Monitoring with WindO/I-NV2
25
Monitor F
unction
●
External Device Monitor
Displays the state of external devices connected to the MICRO/I.
Can be used only for 1:N communication devices.
■ (Connection status)
Displays the state of external devices connected to the MICRO/I. If a red cross appears over the icon of an external
device ( ), communication is stopped.
Clicking the external device icon enables switching between connection and disconnection.
■ (Station No.)
Displays the station number of all external devices used in the project.
Value: Displays the current value of device address in decimal format. To change a value, double-click
a cell and then specify a value.
The value range depends on the data type. For details, refer to Chapter 2 “1.2 Available Data”
on page 2-2.
Click to toggle display of HEX and BIN format. To display HEX and BIN values, click to
display a popup menu, then click HEX and BIN and select the check box.
Hexadecimal, Binary: Displays the current value of device address in hexadecimal and binary format. To change a
value, double-click a cell and then specify a value.
The value range depends on the data type. For details, refer to Chapter 2 “1.2 Available Data”
on page 2-2.
Comments are displayed only after you click next to Value to display a popup menu and
then select the HEX and BIN check box.
• If BIN32, BCD8, or float32 is selected from Data Type for the address of highest number, the values
stored in the device address are displayed repeatedly.
• If BIN32, BCD8, or float32 is selected from Data Type, sequential addresses (lower word to upper
word) are used.
(Connection status)
(Station No.)