IDEC High Performance Series - Manual (Page 465)

WindO/I-NV2 User’s Manual 8-141
8 Selector Switch
8
Bu
tton
s
■ Visible Condition *1
The Selector Switch is displayed while the condition is satisfied. The Selector Switch is hidden while the condition is
not satisfied.
Example: When Trigger Type is While ON and Device is LM 0
While LM 0 is 0, the condition is not satisfied and the Selector Switch is hidden.
While LM 0 is 1, the condition is satisfied and the Selector Switch is displayed.
*1 HG2G-5F, HG3G/4G only
While OFF: Enables the Selector Switch when the device value is 0.
While satisfying the condition:
Enables the Selector Switch when the condition is satisfied.
Data Type: Selects the type of data handled by the conditional expression for the input condition.
This option can only be configured if While satisfying the condition is selected for Trigger Type.
For details, refer to Chapter 2 “1.2 Available Data” on page 2-2.
Device: Specifies the bit device or bit of the word device to serve as the input condition.
This option can only be configured when While ON or While OFF is selected for Trigger Type.
Click
to display the Device Address Settings dialog box. For the device address configuration
procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
Condition: Specifies the conditional expression for the input condition.
This option can only be configured when While satisfying the condition is selected for Trigger
Type.
Click
to display the Trigger Condition Settings dialog box. For the conditional expression
configuration procedure, refer to Chapter 2 “5.2 Setting Conditional Expressions” on page 2-69.
Comment: Used for entering a comment for the input condition. The maximum number is 80 characters.
1
0
Enabled Disabled
Device value
Selector Switch
state
Disabled Disabled Enabled Enabled
Selector Switch
state
Disabled Disabled Disabled Enabled Enabled Enabled
Satisfied
Not satisfied
Condition
LM0:
MICRO/I
0
LM0: 1
Show
Condition
Not
satisfied
Condition
Satisfied
Hide
If a hidden Selector Switch is redisplayed on the screen when Read from Destination Device is selected
for Default Position on the General tab, the display position of the knob changes according to the value
of the device configured for the channel. When Ch1, Ch2, or Ch3 is selected, the knob is displayed at the
same position as before it was hidden, regardless of the device value configured for the channel.