IDEC High Performance Series - Manual (Page 687)

WindO/I-NV2 User’s Manual 11-15
1 Bar Chart
11
Charts
■ Data Type
Selects the data type to be handled by the condition formula.
Can only be set if While satisfying the condition is selected as Trigger Type.
For details, refer to Chapter 2 “1.2 Available Data” on page 2-2.
■ Device
Specifies the bit device or bit of the word device to serve as condition.
Can only be set if While ON or While OFF is selected as Trigger Type.
Click to display the Device Address Settings dialog box. For the device address configuration procedure, refer
to Chapter 2 “5.1 Device Address Settings” on page 2-67.
■ Condition
Sets the condition formula.
Can only be set if While satisfying the condition is selected as Trigger Type.
Click to display the Trigger Condition Settings dialog box. For the conditional expression configuration
procedure, refer to Chapter 2 “5.2 Setting Conditional Expressions” on page 2-69.
While ON: Enables the bar chart when the device value is 1.
Example: When While not satisfying the condition is Not update Chart data
While OFF: Enables the bar chart when the device value is 0.
Example: When While not satisfying the condition is Not update Chart data
While satisfying the condition: Enables the bar chart when the condition is satisfied.
Example: When While not satisfying the condition is Not update Chart data
Device value
1
0
Ch1 data 50
Ch2 data
Display
10
Update
60
30
70
50
Update
80
70
Update
90
90
Do not update Do not update
100 50 0 100 50 0 100 50 0 100 50 0 100 50 0
Device value
1
0
Update
Ch1 data 50
Ch2 data
Display
10
60
30
Update
70
50
Update
80
70
90
90
Do not update Do not update
100 50 0 100 50 0 100 50 0 100 50 0 100 50 0
Update Do not update Do not update
Ch1 data 50
Ch2 data
Display
10
60
30
Update
70
50
Update
80
70
90
90
CondiƟon
SaƟsfied
Not saƟsfied
100 50 0 100 50 0 100 50 0 100 50 0 100 50 0