IDEC High Performance Series - Manual (Page 207)

WindO/I-NV2 User’s Manual 4-21
1 Creating and Manipulating WindO/I-NV2 Project Data
4
Project Set
tings
1.6 Changing Project Settings
●
Changing O/I Type
This section describes how to change the O/I type set in the project data being edited.
1 Click Change O/I Type on the status bar.
The Change O/I Type dialog box is displayed.
2 Select O/I Type, Model, and Installation, and then click OK.
A confirmation message is displayed.
3 Check the message and click OK.
The Destination path for Convert dialog box is displayed.
4 Specify the save location and file name, and then click Save.
The Set Conversion Option dialog box is displayed. However, when converting to the HG1F/2F/2S/3F/4F, proceed to
step
6 .