IDEC High Performance Series - Manual (Page 740)

1 Bit Write Command
12-4 WindO/I-NV2 User’s Manual
1.3 Properties of Bit Write Command Dialog Box
This section describes items and buttons in the Properties dialog box.
●
General Tab
■ Part Name
Enter a name for the part. The maximum number is 20 characters.
■ Action Mode
Select the action to perform when the trigger condition is satisfied from the following:
Set: Writes a 1 to the specified bit device when the trigger condition is satisfied.
Reset: Writes a 0 to the specified bit device when the trigger condition is satisfied.
Momentary: Writes a 1 to the specified bit device when the trigger condition is satisfied.
When the trigger condition is no longer satisfied, a 0 is written to the specified bit device.
1
State of condition
Data written 1
Action Write Write
Condition Condition Condition Condition
Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied
0
State of condition
Data written 0
Action Write Write
Condition Condition Condition Condition
Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied
0
State of condition
Data written 1 0 1
Action Write Write Write Write
Condition Condition Condition Condition
Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied Satisfied Satisfied Satisfied Not satisfied Not satisfied Not satisfied