IDEC High Performance Series - Manual (Page 1046)

3 Multimedia Settings Dialog Box
22-14 WindO/I-NV2 User’s Manual
●
Record Tab
■ Use Event Recording
Select this check box to use the event recording function.
The event recording function has the MICRO/I monitor the state of a trigger device. When the device value changes
from 0 to 1 (when an event occurs), the function records the video and audio before and after the event.
■ Recording Target
Select the target to record out of the signals input from the device.
■ Trigger Device
Specifies the bit device that will trigger the start of recording. This option can only be set when Use Event
Recording is selected.
Click to display the Device Address Settings dialog box. For details, refer to Chapter 2 “5.1 Device Address
Settings” on page 2-67.
■ Recording Time Before Event (sec)
Specifies the amount of time (1 to 15 sec.) to record before the trigger device value changes from 0 to 1. This option
can only be set when Use Event Recording is selected.
■ Recording Time After Event (sec)
Specifies the amount of time (1 to 15 sec.) to record after the trigger device value changes from 0 to 1. This option
can only be set when Use Event Recording is selected.
Video and Audio: Records images and sound.
Video only (No Audio): Records images only.
While data is being recorded after an event occurs with the event recording function and while recorded
data is being saved to the memory card, data cannot be recorded with parts and movie files cannot be
played. Also, during these situations, the value of HG special internal register LSD155-0 changes to 1. For
details, refer to Chapter 32 “HG Special Registers (LSD)” on page 32-5.