IDEC High Performance Series - Manual (Page 686)

1 Bar Chart
11-14 WindO/I-NV2 User’s Manual
●
Trigger Condition Tab
The Trigger Condition tab is displayed in Advanced mode.
The bar chart is enabled while the condition is satisfied, and it is disabled while the condition is not satisfied. Select
the operation when the condition is not satisfied as Not display Chart data or Not update Chart data under
While not satisfying the condition.
Example: When Trigger Type is While ON, Device is LM 0, and While not satisfying the condition is Not display
Chart data
While LM 0 is 0, the condition is not satisfied and the bar chart is not displayed.
While LM 0 is 1, the condition is satisfied and the bar chart is displayed.
■ Trigger Type
Selects the condition to enable the bar chart from the following.
LM0:
MICRO/I
CondiƟon
Not
saƟsfied
0
LM0:
CondiƟon
SaƟsfied
1
Show chart
Hide chart
100 50 0
100 50 0
Data over does not operate for hidden bar charts. Data over is reported if the minimum or maximum is
exceeded when the bar chart changes from hidden to displayed.
Always visible: The bar chart is always enabled.
Ch1 data 50
Ch2 data
Display
10
60
30
70
50
80
70
90
90
Update Update Update Update Update
100 50 0 100 50 0 100 50 0 100 50 0 100 50 0