IDEC High Performance Series - Manual (Page 1350)

2 HG2G-5F, HG3G/4G
34-34 WindO/I-NV2 User’s Manual
●
Adjusting the Touch Panel
A gap may be caused in the operation accuracy of the touch panel by the secular distortion, etc. Readjust the touch
panel according to the following procedure when there is a gap in the operation of the touch panel.
• Touch panel adjustment procedure
1 Press the [Offline], then the Main Menu Screen appears.
2 Press in order of [Initial Setting] → [Initialize] → [Touch Panel Adjust]. The confirmation screen appears and asks
“Adjust Touch Panel setting?”
Press the [Yes], then the Touch Panel Adjust screen appears.
3 Press the center of the X mark, then the position of the mark changes one after another. Press five marks
sequentially.
4 When normally recognized, the confirmation screen of 2 is restored.
At procedure 3 , when pressing a point away from the center of the X mark, a recognition error will result. Then the X
mark returns to the initial position, then repeat the procedure of 3
again.
Make sure to press the center of the mark. This will ensure the accuracy of the touch panel operation.