IDEC High Performance Series - Manual (Page 1134)

1 Monitoring with WindO/I-NV2
25-8 WindO/I-NV2 User's Manual
■ Monitor
The registered device addresses are displayed in a list.
Select the custom monitor list from the List to show the device addresses registered in the list.
Registering the device addresses to monitor
Registering the device addresses to monitor individually
Click Device. Or, double-click a cell under Device Address in Monitor, and then click .
The Device Address Settings dialog box is displayed. For details on configuring device address settings, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-67.
Device Address: The registered device addresses are displayed.
Double-click a cell to register or change a device address. Click to display the Device
Address Settings dialog box. For details on how to configure device address settings, refer to
Chapter 2 “5.1 Device Address Settings” on page 2-67.
toggles between showing and hiding comments. When comments are displayed, click to
display a popup menu, then click Comment and select the check box.
Comment: Displays comments on device addresses saved in Tag Editor. Comments are displayed only
after you click next to Device Address to display a popup menu, then click Comment and
select the check box.
Value: Displays the current value of device address in decimal format. To change a value, double-click
a cell and then enter a value.
The value range depends on the data type. For details, refer to Chapter 2 “1.2 Available Data”
on page 2-2.
Click to toggle display of HEX and BIN format. To display HEX and BIN values, click to
display a popup menu, then click HEX and BIN and select the check box.
Hexadecimal, Binary: Displays the current value of device address in hexadecimal and binary format. To change a
value, double-click a cell and then specify a value.
The value range depends on the data type. For details, refer to Chapter 2 “1.2 Available Data”
on page 2-2.
Comments are displayed only after you click next to Value to display a popup menu and
then select the HEX and BIN check box.
Data Type Selects the data format of the displayed value. For details, refer to Chapter 2 “1.2 Available
Data” on page 2-2.
• If BIN32, BCD8, or float32 is selected from Data Type for the address of highest number, the values
stored in the device address are displayed repeatedly.
• If BIN32, BCD8, or float32 is selected from Data Type, sequential addresses (lower word to upper
word) are used.