IDEC High Performance Series - Manual (Page 135)

WindO/I-NV2 User’s Manual 3-33
5 User Communication
3
Communic
ation
When receiving of 1 frame of data could not be completed by the time the Receiving Time Out duration
elapses from when the trigger condition is satisfied, the value of the Receiving Time Out of the Status
Device LDR110 (address+0, bit 14) changes to 1.
■ Trigger Condition
Set the trigger conditions for transmission or receiving of data.
When TXD is selected as Command Type:
1
0
0
1
0
1
Receive command
Value of LM100 when
Trigger Condition is While ON
Value of Completed Device LM101
Receive data 1 frame
Receiving Time Out duration
Value of Receiving Time Out
(address+0, bit 14)
of Status Device LDR110
1
0
0
1
0
1
Receive command
Value of LM100 when
Trigger Condition is While ON
Value of Completed Device LM101
Receive data 1 frame
Receiving Time Out duration
Value of Receiving Time Out
(address+0, bit 14)
of Status Device LDR110
Trigger Type: A condition for data transmission is selected from the following.
Rising-edge: Data is transmitted when the value of device changes from 0 to 1.
Falling-edge: Data is transmitted when the value of device changes from 1 to 0.
Satisfy the condition:
Data is transmitted when the condition changes from not satisfied to satisfied.
Value of Device
1
0
Action Execution Execution Execution
1
0
Value of Device
Action Execution Execution
Action Execution
Condition
Satisfied
Not satisfied
Execution Execution