IDEC High Performance Series - Manual (Page 594)

5 Message Display
10-82 WindO/I-NV2 User’s Manual
■ Flash
Flashes the text and plate colors.
• When the Change Color by Device check box is cleared
The colors specified by Text Color on the Format tab and Plate Color on the View tab and the colors specified
by Text Color and Plate Color under Flash are alternately displayed.
Device: Specifies the word device that stores the color data for the text or plate.
Click to display the Device Address Settings dialog box. For the device address configuration
procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
This uses address+1 to specify the text and plate colors when the Enable check box under Flash has
been selected.
Color data assignments that are stored to devices are given below.
For color data, refer to Appendix “1 Color Number Correspondence Table” on page A-1.
bit bit
15 8
bit
7
bit
0
Upper byte
Plate color Address
Device
Text color
Plate color when flashing Address+1 Text color when flashing
Lower byte
HG SERIES
HG SERIES
Flashing
Lower byte Upper byte
0 x 1 4 0 x 1 6
Lower byte Upper byte
0 x F 7 0 x 2 3
Text color Plate color
Device
Address
Device
Address+1
Text color
when flashing Plate color
when flashing
MICRO/I External device
0
1
HG SERIES
HG SERIES
HG SERIES
HG SERIES
Flashing
Trigger device
Text Color on the
Format tab
Plate Color
on the View tab
Text Color on the Format tab
Plate Color on the View tab
Text Color under Flash
Plate Color under Flash