IDEC High Performance Series - Manual (Page 1395)

WindO/I-NV2 User’s Manual 34-79
6 HG2S
34
MICRO/
I Specif
ication
s
6.6 Specifications
■ Applicable Standards
Note: These standards are applicable to only the HG2S models equipped with both an emergency stop switch or a
stop switch and an enabling switch.
■ Environmental Specifications
■ Electrical Specifications
■ Construction Specifications
Type No.
This type is used for an emergency stop
SW (red).
This type is used for a stop SW (gray).
Safety Standard
UL508, UL1740
CSA C22.2 No.14
IEC/EN60950
IEC/EN60204-1
IEC/EN60950
IEC/EN60204-1 (compliant)
EMC Standard
IEC61000-6-4
IEC/EN 61131-2
FCC Part15 Class A IEC61000-6-4
IEC/EN 61131-2
FCC Part15 Class A
Operating Ambient Temperature 0 to 40°C (no freezing)
Operating Relative Humidity 20 to 85% RH (no condensation)
Storage Ambient Temperature -20 to +60°C (no freezing)
Storage Relative Humidity 20 to 85% RH (no condensation)
Altitude (Operation) 0 to 2000m
Pollution Degree 2
Corrosion Immunity Free from corrosive gases
Rated Operating Voltage 24V DC
Power Consumption 10W maximum
Power Voltage Range 21.6 to 26.4V DC
Allowable Momentary Power
Interruption
10 ms maximum
Inrush Current 10 ms maximum
Dielectric Strength AC500V, 10mA, 1 minute (between power and earth terminals)
Insulation Resistance 10 MΩ minimum (500V DC megger) (between power and earth terminals)
Vibration Resistance
10 to 55Hz acceleration 9.8m/s 2
2 hours on each of three mutually perpendicular axes
(IEC/EB60068-2-6)
Shock Resistance
98m/s 2 , 11ms (5 shocks on each of three mutually perpendicular axes)
(IEC/EN60068-2-27)