IDEC High Performance Series - Manual (Page 231)

WindO/I-NV2 User’s Manual 4-45
3 Project Settings Dialog Box
4
Project Set
tings
3.3 Host I/F Driver Tab
The Host I/F Driver tab is used to configure the host I/F driver for the host configured in the current project data.
■ O/I Type
Shows the MICRO/I model configured in the current project data.
■ Manufacturer
Shows the host manufacturer configured in the current project data.
■ Protocol
Shows the host I/F driver name configured in the current project data.
■ PLC (Host)
These options configure the host I/F driver to use. For details, refer to the External Device Setup Manual.
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F
Transmission Wait (x 10 msec): Specifies the transmission interval for communication commands (0 to 255).
Time Out (x 100 msec):
Specifies the time to wait for a response from the host (1 to 255).
Retry Cycles: Specifies the number of times to execute a reconnection when the MICRO/I cannot
communicate with the host. When the number of reconnect attempts reaches the
number of times set here, a communication error is displayed.
Enable Pass-Through: Select this check box to use the Pass-Through function.
This option is only displayed for models that can use the Pass-Through function. For
details, refer to Chapter 26 “2 Correspondence model Pass-Through” on page 26-2.
The Pass-Through Tool is required to use the Pass-Through function on the HG2G-S/-5S/-5F and the
HG3G/4G when using a version of WindLDR before Ver. 6.01, another company's PLC programming
software, or a host other than an IDEC host.