IDEC High Performance Series - Manual (Page 709)

WindO/I-NV2 User’s Manual 11-37
2 Line Chart
11
Charts
●
Date and Time (Cursor) Tab
The Date and Time (Cursor) tab is only displayed in Advanced mode when Log Trend (Normal) or Log Trend
(Pen Recorder) is selected for Chart Type on the General tab and the Display cursor check box is selected.
■ Control Cursor Position
This device value is the cursor's display position. The cursor is displayed at the position counted from the left side of
the chart.
This option specifies the word device that is the cursor's display position.
Click to display the Device Address Settings dialog box. For the device address configuration procedure, refer
to Chapter 2 “5.1 Device Address Settings” on page 2-67.
If the value of the device configured by Control Cursor Position is outside the range of points configured by
Display Points on the General tab, the cursor is displayed at the minimum or the maximum value of the display
points.
Example: When Display Points is 50 and the value of the device configured by Control Cursor Position is 100,
the cursor is displayed at the 50 (maximum) position.
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F
Maximum number of display points
Cursor