IDEC High Performance Series - Manual (Page 242)

3 Project Settings Dialog Box
4-56 WindO/I-NV2 User’s Manual
Some functions may not be available depending the Printer Code/Manufacturer selection.
• Color printing is not supported when PCL is selected. The page is not ejected when the Print Button part
is used or when Cancel Printing was selected during printing. Eject the page using the printer controls
before continuing. Otherwise, printing will resume from where it was canceled.
• When SII is selected, pages are printed in monochrome regardless of whether Color or Gray Scale is
selected under Print Color.
• When ESC/P is selected, a 24-pin dot matrix printer can be used. 9-pin dot matrix printers are not
supported. ESC/P control commands including ESC/P2 and ESC/Page are also supported.
• When PictBridge is selected, the color cannot be configured. To print in monochrome, configure the
print color on the printer that is used. When the edge of the data is not printed, enable No Trimming
and Bordered in the printer's settings.
• When connecting the HG2G-5F or the HG3G/4G to a printer, an error may occur on the printer side as an
unsupported device. However, data is sent that satisfies the PictBridge standard when printing, so the
data can be printed correctly.