9 tet - endpoint – Metrohm tiamo 2.4 Manual User Manual
Page 944
5.6 Commands
■■■■■■■■■■■■■■■■■■■■■■
928
■■■■■■■■
tiamo 2.4
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Open the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 934).
[Properties]
Open the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 934).
[Delete]
Delete the external measured value selected in the table.
5.6.3.9.9
TET - Endpoint
Dialog window: Method
▶ TET ▶ Properties... ▶ Thermometric evalua-
tion
▶ [New]/[Properties] ▶ Endpoint
Reaction type
Selection of the reaction type according to which the curve is to be evalu-
ated.
Selection
exothermic | endothermic
Default value
exothermic
EP criterion
Criterion for the recognition of endpoints. Endpoints whose discovered
ERC value is smaller than the value entered here will not be recognized.
for reaction type = exothermic
Input range
-999999 - 0
Default value
-5
for reaction type = endothermic
Input range
0 - 999999
Default value
5