Metrohm tiamo 2.4 Manual - Manual (Page 1058)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1042 ￭￭￭￭￭￭￭￭
tiamo 2.4
Identification Description
.STY Type of stop with which the command was stopped:
1 = normal; 0 = manual or after error
.PK{#}.ABS Absorbance of the peak with the greatest absorbance
(maximum absorbance) for evaluation # (1 - 9)
.PK{#}.TRN Transmission of the peak with the greatest absorb-
ance (minimum transmission) for evaluation # (1- 9) in
%
.PK{#}.CNT Intensity of the peak with the greatest absorbance
(maximum intensity) for evaluation # (1 - 9)
.PK{#}.CNR Intensity in reference spectrum 'Command
name'.PK{#}.WVL for evaluation # (1 - 9)
.PK{#}.CND Intensity in dark spectrum 'Command
name'.PK{#}.WVL for evaluation # (1 - 9)
.PK{#}.WVL Wavelength of the peak with the greatest absorbance
for evaluation # (1 - 9) of the discovered maximum
.PK{#}.SAT Specification as to whether the detector was satura-
ted with 'Command name'.PK{#}.WVL for evaluation
# (1 - 9)
5.6.4.13.2 MEAS Spec - General/Hardware
Tab: Method ▶ MEAS Spec ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the instrument are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. Only devices
with which the command can be executed are available.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.