Metrohm tiamo 2.4 Manual - Manual (Page 1623)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 Manual control
tiamo 2.4
￭￭￭￭￭￭￭￭ 1607
702, 716, 718, 719, 720, 721, 736, 794
Selection
Bit-pattern with exactly 8 characters (0, 1, *,
p) | ******** | Signal pattern
Default value ********
Spectrometer
Selection
Bit-pattern with exactly 10 characters (0, 1, *,
p) | ********** | Signal pattern
Default value **********
The output lines are numbered from right to left:
Output 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Bit 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Examples:
************1* sets the output line 1 to enabled (= set), which would
result in a stop command for a connected Titrino, for example.
************0* sets the line to inactive.
NOTE
We recommend masking the irrelevant output lines with an asterisk *
so as not to modify these line conditions.
NOTE
For Titrinos with 3 output lines, only 3 characters can be entered. If sig-
nal pattern is selected, also only the first 3 characters will be used.
[Set]
Set the bit pattern defined under Outputs.
8.4.4 Sample changer functions
8.4.4.1 Sample changer - Overview
Program part: Manual
If a tower of a sample changer is selected in the subwindow for the device
selection, then the functions that are possible with this sample changer
are displayed together with the corresponding parameters in the sub-
window for functions/parameters.