Metrohm tiamo 2.4 Manual - Manual (Page 1546)

7.9 774 Oven Sample Processor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1530 ￭￭￭￭￭￭￭￭
tiamo 2.4
7.9 774 Oven Sample Processor
7.9.1 774 Oven Sample Processor - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties… ▶ Properties - 'De-
vice type' - 'Device name'
The parameters for the device 774 Oven Sample Processor are set on
the following tabs:
￭ General
General device information such as device name, device type, serial
number, etc.
￭ Tower
Properties of the tower. This tab is only displayed if the Oven Sample
Processor is connected to the PC via an RS-232 interface.
￭ Rack
Information on the rack attached. This tab is only displayed if the Oven
Sample Processor is connected to the PC via an RS-232 interface.
￭ Dosing device
Properties of the connector and the dosing devices connected to. This
tab is only displayed if the Oven Sample Processor is connected to the
PC via an RS-232 interface.
￭ Oven
Shows the oven parameters. This tab is only displayed if the Oven Sam-
ple Processor is connected to the PC via an RS-232 interface.
￭ Gas
Shows the parameters for the gas flow. This tab is only displayed if the
Oven Sample Processor is connected to the PC via an RS-232 interface.
￭ RS-232
Selection of the serial interface the device is connected to.
￭ GLP
Information on GLP tests and GLP monitoring.
7.9.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
On the tab General, general properties of the device are displayed.
Device name
Designation of the device (can be freely defined by user).
Entry 50 characters
Default value Device type number_#
Device type
Display of the device type.