Metrohm tiamo 2.4 Manual - Manual (Page 782)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
766 ￭￭￭￭￭￭￭￭
tiamo 2.4
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | Titrando
Default value Titrando
Dosing device
Dosing device
Selection of the number of the dosing device (dosing or exchange unit)
with which the solution is to be dosed. All the dosing device connections
which are possible with the selected device type are displayed.
Titrando
Selection
1 | 2 | 3 | 4
Default value 1
855
Selection
1 | 2 | 3
Default value 1
Titrino
Selection
internal D0
736, 751, 799
Selection
internal D0 | external D1 | external D2
Default value internal D0
Solution
Input of a solution name or selection of a solution from the solutions
defined in the solution table. If intelligent exchange or dosing units are
used, then a check will be made in the method sequence to see whether
the correct solution has been set on the selected dosing device and
whether the dosing device type is correct. With non-intelligent exchange
or dosing units, only the cylinder volume is checked. At the start of the