Metrohm tiamo 2.4 Manual - Manual (Page 691)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 675
Identification Description
.EP{x}.TIM Time in s until the endpoint × (1 - 9) is reached
.EP{x}.VOL Volume for the endpoint × (1 - 9) in mL
.ETE End temperature (temperature after the command
has been processed) in °C
.EVT End volume (total dosed volume at the end of the
command) in mL
.FIN Command status; 1 = Command has ended at
least once, 0, invalid (variable not available) =
Command has never ended
.FP{x}.DME Measured value differential for the fixed endpoint ×
(1 - 9) in the unit of the measured value
.FP{x}.MEA Measured value for the fixed endpoint × (1 - 9) in
mS/cm
.FP{x}.TEM Temperature for the fixed endpoint × (1 - 9) in °C
.FP{x}.TIM Time in s until the fixed endpoint × (1 - 9) is
reached
.FP{x}.VOL Volume for the fixed endpoint × (1 - 9) in mL
.IME Initial measured value (measured value before start
conditions are processed) in the unit of the mea-
sured value
.ITE Initial temperature (temperature before start condi-
tions are processed) in °C
.LP.CAx Calculated value × (1 - 3) for the last measuring
point in the measuring point list
.LP.DME Measured value differential for the last measuring
point in the measuring point list in the unit of the
measured value
.LP.EXx External value × (1 - 3) for the last measuring point
in the measuring point list
.LP.MEA Measured value for the last measuring point in the
measuring point list in the unit of the measured
value
.LP.TEM Temperature for the last measuring point in the
measuring point list in °C