Metrohm tiamo 2.4 Manual - Manual (Page 1585)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4
￭￭￭￭￭￭￭￭ 1569
Entry 1000 characters
Default value empty
7.15.4 Properties - Settings
Tab: Configuration ▶ Device ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Settings
Barcode reader ID
Shows the identification of the barcode reader.
Input target
Selection of the field into which the output from the barcode reader is to
be entered.
Selection Active input field | Method | ID1…16 | Sample
size | Sample size unit | Sample position
Default value Active input field
[Connect]
Establishes a connection to the barcode reader. The dialog window
Establish connection (see Chapter 7.15.6, page 1571) appears.
[Disconnect]
Disconnects the connection to the barcode reader (only then the device
can be deleted out of the configuration).
7.15.5 Properties - GLP
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ GLP
GLP test date
Date of the last GLP test. This date can be selected by clicking on in
the dialog window Select date (see Chapter 2.5.1, page 90).
Comment on GLP test
Comment on GLP test.
Entry 1000 characters
Monitoring of GLP validity
Monitoring of GLP validity
on | off (Default value: off)
If this option is enabled then the time interval for the GLP test will be
monitored.