Metrohm tiamo 2.4 Manual - Manual (Page 395)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
4 Database
tiamo 2.4
￭￭￭￭￭￭￭￭ 379
Statistics
on | off (Default value: off)
Shows the statistics results.
Display for calculation commands
Selection of the information to be displayed on the tabs Calculation_#.
Results
on | off (Default value: on)
Shows the results defined in the calculation command.
Statistics
on | off (Default value: off)
Shows the statistics results.
Assignment
on | off (Default value: on)
Shows the assignment.
Formula
on | off (Default value: on)
Shows the calculation formula.
Variables
on | off (Default value: off)
Displays the variables used in the formula.
4.8 Subwindow Curves
4.8.1 Curves - General
Subwindow: Database ▶ Curves
Subwindow Curves
The subwindows Curves 1...5 are subwindows in the program part
Database, in which the measuring points generated by the measuring
commands for the focused determination in the Determination table
are shown as a graph. When navigating in the determination overview
this data will be updated automatically (with a certain delay).
The subwindows Curves 1...5 can be switched on in the program part
Database during the definition of the layout and thus made visible. They
can be enlarged and reduced as required; they can also be maximized.