Metrohm tiamo 2.4 Manual - Manual (Page 33)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1 Introduction
tiamo 2.4
￭￭￭￭￭￭￭￭ 17
￭ If a pH calibration or an electrode test was carried out with an intelli-
gent sensor on one system (tiamo and Titrando) and the sensor was
then transferred to another system, then the Calibration tempera-
ture field on the Calibration data tab was empty.
￭ If Monitor TC data was enabled for a sample solution (TC conductiv-
ity) and the validity for the TC data had expired, then no message was
displayed during the method run of a measurement.
Manual program part
￭ If the measurement of a spectrum with the Avantes spectrometer was
canceled by clicking on [Stop], the [Stop] button correctly changed to
[Start], but the recording of the spectrum continued (the error was
already eliminated in tiamo 2.3, Patch 1).
￭ When trying to approach a lift height greater than 90 mm with the
774 Oven Sample Processor, the program was unexpectedly finished.
￭ A table with the gas flow factors for various carrier gases enabling the
correct determination of the gas flow in the 874 USB Oven Sample
Processor has been added to the online help.