Metrohm tiamo 2.4 Manual - Manual (Page 1263)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1247
5.6.8.2.5 CALC - Result properties
5.6.8.2.5.1 Result - Definition
Tab: Method ▶ CALC ▶ Properties... ▶ [New] ▶ [Continue] ▶ Result - Definition
The result calculation is defined on this tab.
Result name
Name of the result. This name will be shown in the result view as well as
in the report. The result name can be used in further calculations as varia-
ble RS.Result name.VAL.
Entry 50 characters
Default value Res01 … Res025
Formula
Display of the calculation formula of the result. The formula editor to
enter the calculation formula is opened with a click on or by double-
clicking in the window in which the formula can be entered (see Chapter
2.4, page 30). The result of the calculation formula defines the result type
(Number, Text or Date/time).
Entry 1000 characters
Unit
Unit of the result for the output (text only). The unit can be used in further
calculations as variable 'RS.Result name.UNI'.
Entry 16 characters
Selection empty | ppm | % | g/L | mg/L | mg/mL | mg/100
g | mol/L | mmol/L | mL | µL | g | mg | µg | °C | s |
mV | µA | S/cm | mS/cm | µS/cm | µL/min
Default value empty
Decimal places
Number of decimal places for the output of the calculated result. This
parameter is ignored for results of the type text or date/time.
Input range 0 - 5
Default value 2
Assignment
Assigns the result to one of the 25 possible result columns RS01 ... RS25
in the determination overview in which the result is entered.
Selection RS01 … RS25 | first unallocated result varia-
ble | none
Default value first unallocated result variable