Metrohm tiamo 2.4 Manual - Manual (Page 1608)

7.19 Balances
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1592 ￭￭￭￭￭￭￭￭
tiamo 2.4
Selection None | Odd | Even
Default value None
Stop bit
Number of stop bits.
Selection 1 | 2
Default value 1
Handshake
Type of data transmission protocol.
Selection None | HW | SW
Default value None
Timeout
Maximum waiting time for receiving characters. If this time is exceeded,
receiving will be stopped.
Input range 1000 - 9999 ms
Default value 2000 ms
Terminator for send
Terminator for send in hexadecimal code.
Selection \0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value \0D\0A
(\0D = CR, \0A = LF)
Terminator for receiving
Final character for receiving in hexadecimal code.
Selection \0D | \0D\0A | \0D\0A\0A | \0D\0D\0A
Default value \0D\0A
(\0D = CR, \0A = LF)
Code page
Code page used for the data transfer.
Selection Cp437 | Cp850 | Cp852 | ASCII
Default value Cp437
[Connect]
Establishes the connection to the balance. The dialog window Establish
connection appears (see Chapter 7.19.5, page 1594).
[Disconnect]
Disconnects the connection to the balance (only then the device can be
deleted out of the configuration).