Metrohm tiamo 2.4 Manual - Manual (Page 1280)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1264 ￭￭￭￭￭￭￭￭
tiamo 2.4
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | Titrando
Default value Titrando
Remote Box
Selection of the Remote Box at which the lines are to be scanned.
Titrando, 856, 867, 814, 815, 855, 864, 874
Selection
1 | 2 | 3 | 4
Default value 1
Scan lines
Input signal
Input of the binary pattern for the expected input signal or selecting a pre-
defined signal pattern.
It is possible to enter the following characters:
0 = line inactive
1 = line active
* = any line status
Selection Bit-pattern with 8 characters (0, 1, *) |
******** | Signal pattern
Default value ********
The bits are numbered from right to left:
Input 7 6 5 4 3 2 1 0
Bit 7 6 5 4 3 2 1 0
Example: