Metrohm tiamo 2.4 Manual - Manual (Page 62)

2.4 Formula editor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
46 ￭￭￭￭￭￭￭￭
tiamo 2.4
Identifica-
tion Description Commands
.LP.TEM Temperature for the last measur-
ing point in the measuring point
list in °C DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS, DOS,
ELT MEAS
.LP.TIM Time in s until the last measuring
point in the measuring point list is
reached DET, MET, SET,
KFT, KFC, BRC,
STAT, MEAS
(without Ref,
Spec), CAL Cond,
CAL MEAS, DOS,
ELT MEAS
.LP.TRN Transmission of the last measur-
ing point of the measuring point
list in % MEAS Opt, MEAS
Opt Conc, CAL
MEAS Opt
.LP.UGE Voltage at the generator elec-
trode for last measuring point of
the measuring point list in V; in
case of measurements with 756,
831: 0 = not defined, 1 = <14
V, 2 = 14 - 28 V, 3 = >28 V KFC, BRC
.LP.VOL Volume for the last measuring
point in the measuring point list
in mL DET, MET, SET,
KFT, STAT, DOS
.LPO Current absolute lift position in
mm (entry when ending the com-
mand) LIFT
.LST Start time of the loop command
(Date/Time) LOOP, CAL
LOOP, ELT LOOP
.MA.CNT Intensity for maximum measured
value in counts MEAS Opt
.MA.MEA Maximum measured value in the
unit of the measured value DET, MET, SET,
KFT, STAT, MEAS
(without Conc,
Ref, Spec)