Metrohm tiamo 2.4 Manual - Manual (Page 1253)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1237
Init.temp.
With Init.temp. the cuvette heating is switched on at the same time
as the device and the cuvette is heated up to this temperature. The ini-
tial temperature is entered and altered in tiamo.
off
Switch off the heater.
5.6.7.9 FLOW
5.6.7.9.1 FLOW - Overview
Dialog window: Method ▶ FLOW ▶ Properties... ▶ FLOW - 'Command name'
Command for the control of the gas flow.
Devices
This command can be executed with the following instruments:
Sample changers: 774, 874
Appearance
The command has the following appearance:
Parameters
The parameters for the FLOW command are set in the following dialog
window:
￭ FLOW - Properties
Command variables
The following command variables are generated by the FLOW command
in the method run and can be used in formulas under the designation
'Command name.Variable identification':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended