Metrohm tiamo 2.4 Manual - Manual (Page 759)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 743
Identification Description
.SME Start measured value (measured value after process-
ing the start conditions) in the unit of the measured
value
.STE Start temperature (temperature after processing the
start conditions) in °C
.STY Type of stop with which the command was stopped:
1 = normal; 0 = manual or after error
.SVA Start volume absolute (volume that was added
according to the start condition "start volume") in mL
.SVT Total start volume (volume that was added according
to all three start conditions) in mL
.TITER Titer value of the solution used for the command
5.6.3.4.5.2 SET Ipol - General/Hardware
Tab: Method ▶ SET Ipol ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the instrument, the dosing device, the sensor
and the stirrer are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead