Metrohm tiamo 2.4 Manual - Manual (Page 1309)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1293
[E-mail]
Open the dialog window Send E-mail for defining the E-mail parameters
(see Chapter 2.6.1, page 93).
Acoustic signal
on | off (Default value: off)
If this option is enabled, an acoustic signal will be emitted in addition to
the message defined above.
5.6.10.6 SEQUENCE
5.6.10.6.1 SEQUENCE - Overview
Dialog window: Method ▶ SEQUENCE ▶ Properties... ▶ SEQUENCE - 'Command
name'
Command for combining a sequence of individual commands into a single
command. This command is used only for the more readily comprehensi-
ble structuring of methods.
Appearance
The command has the following appearance:
Parameters
The parameters for the SEQUENCE command are configured in the fol-
lowing dialog window:
￭ SEQUENCE
Command variables
The following command variables are generated by the SEQUENCE com-
mand in the method run and can be used in formulas under the designa-
tion 'Command name.Variable identification':
Identifi-
cation Description
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command has
never been started
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended