Metrohm tiamo 2.4 Manual - Manual (Page 1538)

7.8 778/789 Sample Processor
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1522 ￭￭￭￭￭￭￭￭
tiamo 2.4
￭ MSB #
Properties of the MSB connector 1...3 and the peripheral devices con-
nected to. These tabs are only displayed if the Sample Processor is con-
nected to the PC via an RS-232 interface.
￭ RS-232
Selection of the serial interface the device is connected to.
￭ GLP
Information on GLP tests and GLP monitoring.
7.8.2 Properties - General
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ General
On the tab General, general properties of the device are displayed.
Device name
Designation of the device (can be freely defined by user).
Entry 50 characters
Default value Device type number_#
Device type
Display of the device type.
Program version
Shows the program version of the device.
Only visible with devices that have their own firmware.
[Update]
Opens the dialog window Load new program version (see Chapter
7.17.6, page 1582).
This button is only displayed with devices that have their own firmware. It
is only active if the device has an old program version not supported by
tiamo and which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Data storage under legal control
Indicates whether the balance has its own data storage under legal con-
trol.