Metrohm tiamo 2.4 Manual - Manual (Page 1020)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1004 ￭￭￭￭￭￭￭￭
tiamo 2.4
Fixed value
Value of the fixed endpoint.
Measured value
Input range
-20.0 - 150.0 °C
Time
Input range
0.0 - 999999.9 s
5.6.4.8 MEAS T/Flow
5.6.4.8.1 MEAS T/Flow - Overview
Dialog window: Method ▶ MEAS T/Flow ▶ Properties... ▶ MEAS T/Flow - 'Com-
mand name'
Command for Temperature and gas flow measurements.
Devices
This command can be executed with the following devices:
Sample Processor: 774, 874
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS T/Flow are configured on the
following 4 tabs:
￭ General/Hardware
Parameters for device.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluation
Defining further methods for evaluating measurement curves.
￭ Additional measured values
Defining further measured values which can be saved as additional col-
umns in the measuring point list.
Command variables
The following command variables are generated in the method run by the
command MEAS T/Flow and can be used in formulas under the designa-
tion 'Command name.Variable designation':