Metrohm tiamo 2.4 Manual - Manual (Page 459)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 443
Identification Description
In the following lines you will find the method variables (sample data)
present in the default settings which appear in the Run subwindow
and which can be edited and deleted in the START command of the
corresponding method.
Sample size.VAL Value of 'Sample size' (Number)
Sample size.OVF Exceeding limit for 'sample size' (Num-
ber)
Unit.VAL Value of 'Unit'. (Text)
Unit.OVF Exceeding limit for 'unit' (Number)
Sample position.VAL Value of 'Sample position' (Number)
Sample position.OVF Exceeding limit for 'sample position'
(Number)
ID1 (…3).VAL Value of 'ID1…3' (Text)
ID1 (…3).OVF Exceeding limit for 'ID…3' (Number)
5.6.2.2.2 START - General
Tab: Method ▶ START ▶ Properties... ▶ START 'Command name' ▶ General
Command name
Name of the command.
Entry 25 characters
Workplace view
Workplace view
Selection Current view | View
Default value Current view
Current view
If this option is enabled, the current view of the workplace remains
opened when starting a determination.
View
If this option is enabled, the selected workplace view is automatically
opened when starting a determination.
If the option View is selected, then a workplace view can be selected
from those available in the list box.
Selection 'Workplace view'