Metrohm tiamo 2.4 Manual - Manual (Page 1523)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4
￭￭￭￭￭￭￭￭ 1507
[Update]
Opens the dialog window Load new program version (see Chapter
7.17.6, page 1582).
This button is only displayed with devices that have their own firmware. It
is only active if the device has an old program version not supported by
tiamo and which can be updated by tiamo itself.
Device serial number
Shows the serial number of the device.
Set to work
Shows the date on which the device was automatically added to the
device table.
Data storage under legal control
Indicates whether the balance has its own data storage under legal con-
trol.
Only visible and editable with Sartorius balances
Selection
on | off
Default value off
Remarks
Remarks about the device.
Entry 1000 characters
Default value empty
7.6.3 Properties - MSB #
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ MSB #
On the tabs MSB # the properties of the connector and the devices con-
nected to are displayed.
Request for dosing device preparation
Selection when the request for carrying out the command PREP (see
Chapter 5.6.6.5.1, page 1207) (prepare) is to be shown for the dosing
device connected to the MSB.
At program start
on | off (Default value: on)
If this option is switched on then at each program start the request to pre-
pare the dosing device will appear.