Metrohm tiamo 2.4 Manual - Manual (Page 1537)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4
￭￭￭￭￭￭￭￭ 1521
7.7.9 External position
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ Tower ▶ [Edit] ▶ External position #
In the dialog window External position # a Swing angle and a specific
Work position can be defined for each external position. Shift position
and Rinse position can only be defined for all 4 external positions
together. No Special position can be defined for external positions.
Angle
Definition of the swing angle for the selected external position. The offset
is made up of a design-dependent angle (approximately 8-9°) together
with the robotic arm offset from the Robotic arm properties (see Chapter
7.7.8, page 1519). The maximum swing range is also defined under
Robotic arm properties.
Input range (Offset) - (Offset + max. swing range) °
Default value 60.0 °
Work position
Definition of the work position for the selected external position.
Input range 0 - 235 mm
Default value 0 mm
7.8 778/789 Sample Processor
7.8.1 778/789 Sample Processor - Overview
Dialog window: Configuration ▶ Devices ▶ [Edit] ▶ Properties… ▶ Properties - 'De-
vice type' - 'Device name'
The parameters for the devices 778 Sample Processor and 789
Robotic Sample Processor XL are set on the following tabs:
￭ General
General device information such as device name, device type, serial
number, etc.
￭ Tower #
Properties of Tower 1 and Tower 2 (if present). These tabs are only dis-
played if the Sample Processor is connected to the PC via an RS-232
interface.
￭ Rack
Information on the rack attached. This tab is only displayed if the Sam-
ple Processor is connected to the PC via an RS-232 interface.