Metrohm tiamo 2.4 Manual - Manual (Page 1151)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1135
off
The temperature will not be measured. The temperature entered man-
ually under Temperature on the Measuring parameters tab will be
used.
Stirrer
The Stirrer section is only displayed for Device type = 089 Photome-
ter.
Stirrer
Selection of the stirrer.
Selection 1 | off
Default value off
Stirring rate
Setting the stirring rate.
Input range 0 - 15
Default value 5
Switch off automatically
on | off (Default value: on)
If this check box is activated, the stirrer will be switched off automatically
when the command has finished.
5.6.5.11.3 CAL MEAS Opt - Measuring parameters
Tab: Method ▶ CAL MEAS Opt ▶ Properties... ▶ Measuring parameters
Command name
Name of the command.
Entry 25 characters
The measuring parameters for the calibration are defined on this tab.
Measuring parameters for the Avantes spectrometer
Wavelength
Wavelength at which the measured quantity (absorbance) is recorded.
Input range 100.0 - 2,000.0 nm
Default value 400.0 nm
Blank value
Value by which the measured quantity (absorbance) is corrected. Here an
expression can also be entered through the formula editor (e.g. xx.EME