Metrohm tiamo 2.4 Manual - Manual (Page 1194)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1178 ￭￭￭￭￭￭￭￭
tiamo 2.4
time * dosing rate and is not shown (see Chapter 5.6.6.3.2, page
1166).
Selection Volume/dosing rate | Volume/dosing time |
Dosing rate/dosing time
Default value Volume/dosing rate
Volume
Fixed volume that is to be dosed. This parameter is only displayed for
Dosing criterion = Volume/Dosing rate or Volume/Dosing time.
Input range 0.00000 - 99999.9 mL
Default value 10.0000 mL
Dosing rate
Rate at which dosing should take place. The maximum dosing rate
depends on the cylinder volume of the exchange unit or dosing device
used. If the entered dosing rate is too high for the selected dosing device,
it will automatically be reduced during dosing to the largest possible
value. This parameter is only displayed for Dosing criterion = Volume/
Dosing rate or Dosing rate/Dosing time.
Titrando, 855
Input range
0.01 - 166.00 mL/min
Default value maximum mL/min
Titrino
Input range
0.01 - 150.00 mL/min
Default value maximum mL/min
NOTE
The dosing rate should be reduced for viscous liquids.
Dosing time
Time during which dosing is to be carried out. This parameter is only dis-
played for Dosing criterion = Volume/Dosing time or Dosing rate/
Dosing time.
Input range 0 - 9999999 s
Default value 100 s
Pause
Waiting period before dosing is started.