Metrohm tiamo 2.4 Manual - Manual (Page 1555)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Devices
tiamo 2.4
￭￭￭￭￭￭￭￭ 1539
Selection COM1 | COM2 | … | COMn
Default value COMn
COMn
First free COM port.
Baud rate
Transmission speed. Additionally, this baud rate must be set on the device
itself.
Selection 1200 | 2400 | 4800 | 9600
Default value 9600
[Connect]
Establishes a connection to the RS-232 device.
[Disconnect]
Disconnects the connection to the RS-232 device.
NOTE
These parameters are only editable for devices with status not ok
(power supply and/or RS connection interrupted).
7.10.4 Properties - GLP
Tab: Configuration ▶ Devices ▶ [Edit] ▶ Properties... ▶ Properties - 'Device type' -
'Device name' ▶ GLP
GLP test date
Date of the last GLP test. This date can be selected by clicking on in
the dialog window Select date (see Chapter 2.5.1, page 90).
Comment on GLP test
Comment on GLP test.
Entry 1000 characters
Monitoring of GLP validity
Monitoring of GLP validity
on | off (Default value: off)
If this option is enabled then the time interval for the GLP test will be
monitored.
Monitoring can only be switched on when a date has been entered in
the field GLP test date.