Metrohm tiamo 2.4 Manual - Manual (Page 497)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 481
Lower limit pH
Value for the lower limit of the Gran evaluation range.
Input range -20.000 - 20.000
Default value -20.000
Upper limit pH
Value for the upper limit of the Gran evaluation range.
Input range -20.000 - 20.000
Default value 20.000
5.6.3.2.2.8 DET pH - Additional measured values
Tab: Method ▶ DET pH ▶ Properties... ▶ Additional measured values
Command name
Name of the command.
Entry 25 characters
A maximum of 6 additional measured values can be defined on this tab.
These values can then be saved together in additional measured value col-
umns with the measured values present in the default settings.
Additional calculated measured values
Additional calculated measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be calculated from existing measured values and saved, which can also be
presented as curves under the designation Calculated 1…3 and used in
formulas as variables 'Command name.CA1…3'.
[New]
Opens the Calc. measured value # dialog window, in which the param-
eters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 933).
[Properties]
Opens the Calc. measured value # dialog window, in which the param-
eters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 933).
[Delete]
Deletes the calculated measured value selected in the table.