Metrohm tiamo 2.4 Manual - Manual (Page 1283)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1267
5.6.9.4.3 SEND - Send event message
Dialog window: Method ▶ SEND ▶ Properties... ▶ [New]/ [Properties] ▶ Send event
message
Receiver
Selection of the type of receiver.
Selection System | Command
Default value System
Selection
Selection of the receiver address. All of the command names already
defined in the method are available for Receiver = Command. This field
is empty and cannot be edited for Receiver = System.
Selection 'Command name' | 'empty'
Default value 'empty'
Event message
Selection of the event message to be sent. The following event messages
can be selected depending on the type of receiver:
System
Selection
Quit | Hold | Stop
Default value Quit
Command
Selection
Quit | Hold | Continue | Start Titration
Default value Quit
Receiver Selec-
tion
Event
mes-
sage
Significance
System - Hold Hold determination (all tracks).
This corresponds to the [Hold]
button in the dialog window
Run in the program part Work-
place.
System - Quit Cancel determination (Series con-
tinues).
System - Stop Stop determination and series.
This corresponds to the [Stop]
button in the dialog window
Run in the program part Work-
place.