Metrohm tiamo 2.4 Manual - Manual (Page 1419)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
6 Configuration
tiamo 2.4
￭￭￭￭￭￭￭￭ 1403
sensors and the Thermoprobe, the device to which the sensor is con-
nected is shown here automatically.
Selection Device selection | 'empty'
Default value 'empty'
Measuring input
For nonintelligent sensors it is possible to select here the measuring input
to which the sensor is connected. The connection of a sensor to a particu-
lar measuring input is not checked during the run. This parameter only
appears if a Device has been selected. For intelligent sensors and the
Thermoprobe the measuring input to which the sensor is connected is
shown here automatically.
Selection 1 | 2
Default value 1
Comment
Possibility of entering remarks about the sensor.
Entry 24 characters
Default value 'empty'
Set to work
The current date is automatically entered here for a newly added sensor.
When an existing sensor is edited, the date can be selected after clicking
on in the Select date dialog window (see Chapter 2.5.1, page 90).
Sensor monitoring
on | off (Default value: off)
If this option is activated, then the working life of the sensor will be moni-
tored.
Working life
Working life of the sensor in days. If a value is entered here, then the
Expiry date will be automatically adjusted.
Input range 0 - 999 days
Default value 999 days
Expiry date
Expiry date of the sensor. The date can be selected by clicking on in
the Select date dialog window (see Chapter 2.5.1, page 90). After a
date has been entered, the value for the Working life will be automati-
cally adjusted.