Metrohm tiamo 2.4 Manual - Manual (Page 1031)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1015
Input range 0 - 999999 s
Default value 0 s
Max. waiting time
If the signal drift has not yet been reached, then the measured value will
be accepted when the maximum waiting time has elapsed. If the waiting
time has not been newly entered then a waiting time that is suitable for
the drift will be calculated automatically according to the following equa-
tion:
Input range 0 - 999999 s
Default value 52 s
Measuring interval
Time interval for entering a measuring point in the measuring point list.
Input range 0.1 - 999999.0 s
Default value 2.0 s
Stop measured value
Stop when the entered measured value has been reached since the start
of the measurement.
Input range 0 - 1E+99
Selection off
Default value off
off
No stop.
Measurement without drift control
If the option Measurement without drift control has been selected,
then the following parameters will be displayed:
Duration of measurement
Maximum period of time for measurement.
Input range 0 - 999999 s
Default value 120 s
Measuring interval
Time interval for entering a measuring point in the measuring point list.
Max. number of entries?
Input range 0.1 - 999999.0 s
Default value 2.0 s