Metrohm tiamo 2.4 Manual - Manual (Page 1149)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1133
Identifica-
tion Description
.EME End measured value (measured value after processing of
the command) in the unit of the measured value
.ETE 1) End temperature (temperature after the command has
been processed) in °C
.FIN Command status; 1 = Command has ended at least
once, 0, invalid (variable not available) = Command
has never ended
.IME Initial measured value (measured value before start con-
ditions are processed) in the unit of the measured value
.ITE 1) Initial temperature (temperature before start conditions
are processed) in °C
.LP.CNT Transmission of the last measuring point in the measur-
ing point list in %
.LP.MEA Measured value for the last measuring point in the mea-
suring point list in the unit of the measured value
.LP.TEM Temperature for the last measuring point in the measur-
ing point list in °C
.LP.TIM Time in s until the last measuring point in the measuring
point list is reached
.LP.TRN Transmission of the last measuring point in the measur-
ing point list in %
.MTE Temperature measurement with sensor; (1 = on, 0 =
off)
.NMP Number of measuring points in measuring point list
.STY Type of stop with which the command was stopped: 1
= normal; 0 = manual or after error
1) Command variable is invalid for the Avantes spectrometer
5.6.5.11.2 CAL MEAS Opt - General/Hardware
Tab: Method ▶ CAL MEAS Opt ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the instrument are defined on this tab.