Metrohm tiamo 2.4 Manual - Manual (Page 1069)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1053
089 Photometer
Input range
0.25 - 999,999.00 s (Increment: 0.25)
Default value 2.0 s
Stop measured value
Stop when the entered measured value has been reached since the start
of the measurement.
Input range 0 - 4,000 mAU
Selection off
Default value off
off
No stop.
Temperature
The Temperature section is only displayed for Device type = 089 Pho-
tometer.
Temperature
Measuring temperature, which can be entered manually. If a temperature
sensor is connected and the Temperature measurement is set to con-
tinuous on the General/Hardware tab under Sensor, then the temper-
ature will be measured continuously.
Input range 20.0 - 60 °C
Default value 25.0 °C
5.6.4.14.4 MEAS Opt - Evaluations
Tab: Method ▶ MEAS Opt ▶ Properties... ▶ Evaluations
Command name
Name of the command.
Entry 25 characters
The following additional methods for evaluation of measurement curves
can be activated and defined on this tab.
Fixed endpoint evaluation
Fixed endpoint evaluation
on | off (Default value: off)
If this option is activated, then the associated values for the other mea-
sured quantities will be interpolated with a fixed measured quantity (Mea-
sured value or Time) for the fixed endpoint from the measuring point
list.