Metrohm tiamo 2.4 Manual - Manual (Page 55)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
2 General program functions
tiamo 2.4
￭￭￭￭￭￭￭￭ 39
Identifica-
tion Description Commands
.CAL Status of the calibration: 1 = cali-
brated normally, 0 = can-
celed, because reference wave-
length was not found. CAL Spec
.CBY Command status; 1 = Condi-
tioning activated, 0 = Condi-
tioning deactivated SET, KFT, KFC,
BRC
.CLC Cell constant of the sensor used
in the command (with conductiv-
ity sensors) MET Cond, MEAS
Cond, CAL Cond
.COD Coefficient of determination (R 2 ),
which is calculated on the basis of
the calibration function and of
the confidence interval.
CAL LOOP Opt
.COK Command status; 1 = Condition
requirement fulfilled, 0 = Con-
dition requirement not ful-
filled SET, KFT, KFC,
BRC
.CONC Concentration of the solution
used for the command DET, MET, SET,
KFT, STAT, ADD,
DOS, LQH,
STDADD
.CP{#}.MEA Measured wavelength of the cali-
bration point in nm. If no mea-
sured peak can be assigned, then
not found will be entered. CAL Spec
.CP{#}.REF Reference wavelength of the cali-
bration point in nm. CAL Spec
.CYL Cylinder volume of the exchange
or dosing unit used for the com-
mand DET, MET, SET,
KFT, STAT,
STDADD dos,
STDADD auto,
ADD, DOS, LQH,
PREP, EMPTY