Metrohm tiamo 2.4 Manual - Manual (Page 1237)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
5 Method
tiamo 2.4
￭￭￭￭￭￭￭￭ 1221
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead
If the option not defined is selected as Device name, any device types
or device groups which are able to execute the command can be selected,
independently of the devices in the device table.
Selection Device types | 814 USB Sample Processor
Default value 814 USB Sample Processor
Target
Tower
Selecting the tower of the Sample Processor for moving the robotic arm
to the required position. Both Tower 1 and Tower 2 can always be
selected even if the Sample Processor has only one tower.
Selection 1 | 2
Default value 1
Swing
Selecting the target position for the robotic arm.
Selection External position | Maximum angle | Relative
angle
Default value External position
External position
Swinging to one of the 4 external positions available for each tower.
They are defined in the Tower properties of the Sample Processor.
Maximum angle
Swinging outwards to the maximum permissible angle (see Chapter
7.7.8, page 1519).