Metrohm tiamo 2.4 Manual - Manual (Page 1022)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1006 ￭￭￭￭￭￭￭￭
tiamo 2.4
Identifica-
tion Description
.MA.TEM Temperature for the maximum measured value in °C
.MA.TIM Time in s until the maximum measured value is
reached
.MI.MEA Minimum measured value (temperature) in the unit of
the measured value
.MI.TEM Temperature with minimum measured value in °C
.MI.TIM Time for the minimum measured value in s
.MN.MEA Average of the measured value in the unit of the mea-
sured value
.NMP Number of measuring points in the measuring point
list
.STY Type of stop with which the command was stopped: 1
= normal;0 = manual or after error
5.6.4.8.2 MEAS T/Flow - General/Hardware
Tab: Method ▶ MEAS T/Flow ▶ Properties... ▶ General/Hardware
Command name
Name of the command.
Entry 25 characters
The general parameters for the device are defined on this tab.
Device
Device name
Selection of a device from those available in the device table. The only
devices which shall be offered are those with which the command can
run.
Selection 'Device name' | not defined
Default value not defined
not defined
In this case, the device name must be assigned by the user at the start
of the method.
Device type
Display or selection of the device type. If a device is selected under Device
name, then this Device type field can no longer be edited, and the
device type belonging to the selected device is displayed instead