Metrohm tiamo 2.4 Manual - Manual (Page 113)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
3 Workplace
tiamo 2.4
￭￭￭￭￭￭￭￭ 97
3.1.4 Workplace - Toolbar
Program part: Workplace
Sample table/New… Open a new and empty sample table (see Chapter 3.3.1.1, page 104).
Sample table/Open… Open a saved sample table (see Chapter 3.3.1.2, page 105).
Sample table/Man-
ager…
Manage saved sample tables (see Chapter 3.3.3.1, page 123).
Change layout Change the layout of the loaded workplace view (see Chapter 3.1.7.2, page
100).
Load view Loads a saved workplace view (see Chapter 3.1.7.3, page 101).
Save view Save the current workplace view (see Chapter 3.1.7.4, page 101).
Run test Carry out the run test for determination(s) (see Chapter 3.6.2, page 129).
Split vertically Split the workplace window vertically and display two workplaces side by side
(see Chapter 3.2.3.3, page 104).
Split horizontally Split the workplace window horizontally and display two workplaces below each
other (see Chapter 3.2.3.4, page 104).
Unsplit Unsplit the workplace window (see Chapter 3.2.3.2, page 104).
Logout Logout user (see Chapter 2.2.3, page 23).
tiamo Help Open tiamo Help.
3.1.5 Workplace - Subwindows
Program part: Workplace
Selection
The following subwindows can be displayed in the main window:
￭ Run
Window for controlling sequences and entering sample data. This sub-
window is permanently on display.
￭ Method
Display of the currently loaded method.
￭ Live display 1
Display of live curves, measured values and messages for the running
determination.