Metrohm tiamo 2.4 Manual - Manual (Page 1046)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1030 ￭￭￭￭￭￭￭￭
tiamo 2.4
[Properties]
Open the dialog window Calc. measured value # in which the parame-
ters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 933).
[Delete]
Delete the calculated measured value selected in the table.
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Open the dialog window External measured value # in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 934).
[Properties]
Open the dialog window External measured value # in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 934).
[Delete]
Delete the external measured value selected in the table.
5.6.4.10.6 MEAS Cond - Fixed endpoint evaluation
Dialog window: Method ▶ MEAS Cond ▶ Properties... ▶ Additional evalua-
tions ▶ Fixed endpoint evaluation ▶ [New]/[Property] ▶ Fixed endpoint evalua-
tion #
Measured quantity
Selection of the fixed measured quantity to which the associated values
for the other quantities are to be interpolated from the list of measured
points.
Selection Measured value | Time
Default value Measured value
Fixed value
Value of the fixed endpoint.